February 07, 2010
The
Official Blog of the
anuncios
Minka
Hot new Musical Group
Book Travel
Taxes and Accounting
Treegap
Petersburg,Alaska
Waterfront Home
FOR
SALE
The
first Waterfall
For Sale
2
Fuel Tanks,
Manual Bilge Pump
Bronze Check Valves
Email:
Home
Design and Layout
Equipment
Construction
Phase One - Complete
Phase Two - Active Phase Three - To Be
Cruising Plans
Naval Plaque
Similar Boats Available
| Deck area to be cut out for water tank. Water tank will be about 300 gallons. Click on any picture to see a larger image. Click the back button to return to this page. |  |
 | Deck area cut out. Water tank will use the front bulkhead and longitudinal bulkheads for walls and baffles. The back bulkhead is to size the tank. |
| The limber holes through the main bulkheads are extended under the water tank. |  |
 | Bulkheads set ready for fiberglassing. |
| Bulkheads ae fiberglassed in. The tabs on the tops are to set the lid on. Since the lids will likely be stood on these tabs will help support it. Thru-hulls are used to move the water between tanks. It is only one tank with the stringers used as baffles. Finally, the tanks were cleaned up and sealed with resin with surface agent (wax) in it to seal the resin from the air. This allows the resin to set, without the surface agent the resin surface would stay tacky and the water would taste like fiberglass. |  |
 | Water tanks complete. The ridges (tops of stringers) will have holes drilled in them and some of the foam removed. Bolts to bolt a plywood pad for the generator will be epoxied in. |
| Water tank tops are painted. Most of the engine room will be painted. Next: Back deck component removal |  |